Server Speedtest mit iperf3/en

Aus EUserv Wiki

Version vom 08:13, 3. Mai 2019 bei Sufr1 (Diskussion | Beiträge)
(Unterschied) ← Nächstältere Version | Aktuelle Version (Unterschied) | Nächstjüngere Version → (Unterschied)
Wechseln zu: Navigation, Suche

Server_Speedtest_mit_iperf3

Inhaltsverzeichnis

Server Speedtest mit iperf3



General

To determine the bandwidth available to the server, EUserv provides servers with special software (iperf3) in the network. With an iperf3 measurement, e.g. errors in your own network configuration or also generally in the network can be detected and limited.

Supported Software:

  • iperf3 (not compatible to iperf)



Supported IP-Protocols:

  • IPv4 and IPv6
  • TCP



Supported Networks:

  • all IPv4 and IPv6 Netblocks of EUserv



Connection of the test stations:

  • 1 Gbit/s



Limitations:



  • External Servers are not supported
  • UDP is not supported for security reasons.
  • Maximum one active connection is supported. If more than one client accesses, you'll receive an error message.



Preparation of the speedtest with iperf3


To prepare a speedtest with iperf3, please proceed as follows:

Install iperf3

CentOS



 yum -y install epel-release
 yum -y install iperf3



Run the speedtests with iperf3


To run the speedtest with iperf3 for an IPv4-address, please proceed as follows:

 iperf -c -h iperf3.ipv4.euserv.net




To run the speedtest with iperf3 for an IPv6-address, please proceed as follows:

 iperf -c -h iperf3.ipv6.euserv.net