Kundencenter vServer vServerdaten/en
Aus EUserv Wiki
| Languages: |
Deutsch |
Setting up a vServer
Inhaltsverzeichnis |
Setting up a vServer
General
If you have an EUserv vServer tariff, so there is the possibility to the EUserv Customer comprehensively establish.
You will also need to operate corresponding parameters that you read in the Customer and/or to adjust.
Reading vServerdata
In EUserv customer center, you have the opportunity to read and edit various vServerdata. Select first your vServer contract for which you want to read or change the data.
Once you have selected your vServer contract, so you click on the menu item "vServerdaten" under vServer.
Configuration data of the vServer
In the section "Configuration data vServer" you will find all the data relating to the configuration of your vServer. It describes the first point is the current name of the server ("Server Name: vserver.meinedomain.de").
Under "Server Name (default)" in the beginning of the system automatically assigned name is read. This name can be referred to as "reverse entry". This is the resolution and the name association with the corresponding IP from emergencies.
The "main IP address" contains the main IP address of your vServer. This IP address has been configured during installation and must be used as the main IP. You can not change this, your server is also primarily accessible at this IP address.
The "Netmask" specifies the number of bits at the beginning of the displayed IP address represent the network prefix. If the network mask 255.255.255.0 for example, the so is the network prefix, the 255.255.255. - I.e. all units in this network, the same first three blocks of the IP address have (eg 127.0.0.). The individual instruments differ in the last block of 254 IP addresses theoretically represents the network. The "broadcast address" is used for the communication in the network devices, it is therefore responsible for ensuring that all devices on the same network will receive the data they need. As "default gateway" refers to the router, which is responsible for the network interface point. And eventually even the "default password", which will automatically created for access to your server. For Linux derivatives this password always applies to the administrator account (root).
Status of vServer
Under the heading "Status of vServer" You can read the three parameters on the status of your vServer. "Server Status" tells you whether the server is running ("running") or not available ("n / a"). The point "last check" indicates when the status of the vServer fetched the last time (eg "2012-09-20 09:00:21"). And under "Startup status", you can tell if an automatic reboot is enabled by an operating system installation, or not.
Software data of vServer
"Software data vServer" you get an overview, which operating system (OS) is currently installed on your vServer. You are not only get information which version of the OS is installed, but also the language, whether it supports 64-bit hardware, or in what phase of the support status for the installed version is. Additionally, you can still see which versions of Apache, PHP and MySQL software is installed. You can save yourself so get the cumbersome server-side access to these software information. Additionally, you can see whether the installation is complete ("Installation Status") and whether the rescue system is activated.
Hardware data vServer
"Hardware data vServer" you get the information about it on which Hostnode, speak on which hardware, to her vServer is installed. This reference number is just for support requests of high relevance, as are found as quickly, which can be hardware-server is in the context. The Hostnode is selected with the conversion of your vServer order automatically by the system (according to hardware extent of utilization) and is not changeable by you.
